Low profile transmission jack

[EDISKRAD EHT]

Anyone know where I could buy or rent one?

Doing a clutch job for a T-56 on jack stands licks nuts pretty bad. I got it out but putting it back in is going to be quite the job.

[YoungBuck]

Princess Auto?

[EDISKRAD EHT]

Nope. They only have the big ones.

[Chris99GT]

just use a regular floor jack

[EDISKRAD EHT]

just use a regular floor jack


That's what I was using. It's a PITA though.

[energie]

I'd check Canadian tires website, I'm sure they have some lasttime i checked

maybe scratch that.. this was all i could find on the site

http://www.canadiantire.ca/AST/browse/4/Auto/AutoTools/CreepersJacksStands/PRD~0090021P/Motomaster%2BAluminium%2BJack.jsp

[Cheddar]

a regular jack and a few buddies...

thats how i did my YJ and its the trans/transfer

[egghead]

any luck?

[EDISKRAD EHT]

No. I just used a regular jack with some wood on it to spread the load a bit.

It was pretty sketchy when I didn't have the transmission tunnel to lean it against.


I'd do it again though.;D